The Sensor
is damped to show a return from 90 deg displacement in approx.
2.5sec.
Sensors
can be supplied without damping at no extra cost however a
longer delivery time can be expected
The
Pin-Out View onthe left is shown
DOWN THROUGH THE SENSOR
Vcc must be controlled 5.00 VDC - spike protected
Current - 19mA
Reversing Vcc polarity may distroy the sensor
Output signal is 0.34 to 0.4 V above and belowthe mid
point of 2.4 to 2.6volts. This variation is between different
sensors but should be uniform for both curves on anyonesensor
