ELECTRONIZE
Type FR15 Series
All Electronize
FR series controllers have a selectable operating mode, giving
a choice of high, low or variable frequency. This results in a
high performance low frequency controller, a smooth mid-range
controller and an efficient high frequency controller all in the
same package.
The FR15 series gives the very best speed control over the full
range from idle to full speed. With this new design Electronize
have taken this a step further. Firstly, the microprocessor digitally
measures the input signal and totally rejects any out of limits
signal produced by interference. Next the 'good' signals are used
to calculate a rolling average for the transmitter signal. Slight
interference causes the jitter that makes most controllers seem
harsh. Using this digital technique, interference effects are
reduced by a factor of 8 whilst maintaining a fast response time
of only 160 milli-seconds.
The FR15 series speed controllers are simple to set up, unlike
many microprocessor based units, the controllers are rated to
run at full load in either direction and with no additional load
on the receiver battery in reverse.
The electronic controller plugs directly into the 'throttle' output
of the receiver with no need for a servo.electronic controls do
not have to be linked to the motor other than to stay within the
maximum ratings and furthermore he same control will work equally
well with a large or small motor.
