© 2002 RobotstoreUK all rights reserved
HOME
MICRO-CONTROLLERS

Page - 1


To pages - 0 -
 

INTRODUCTION

ABOUT US
GETTING STARTED
DEFINITIONS + MEANINGS


SHOP HERE

ROBOTS
REMOTE CONTROL+ TELEROBOTICS
CIRCUIT PROTOTYPING
ELECTRONIC COMPONENTS
MICRO-CONTROLLERS
SENSORS + VISION
ACTUATORS
MOTORS
MOTOR CONTROLLERS
POWER + BATTERIES
TEST EQUIPMENT
BOOKS
TOOLS


CONTACT US

CONTACT+ SUPPORT
ORDER + SALES INFO
TERMS+ CONDITIONS
PRIVACY STATEMENT


RESOURCES

LINKS
CURRENCY CONVERTER


Robotica 8Ch RC Servo Controller
The Robotica R/C Servo Controller II is a PIC micro controller based multi-purpose control device ideal for your robotic applications. It connects to the serial port of your PC and is controlled by the Robotica Control Software, which is supplied with the product.

The Robotica R/C Servo Controller II features eight R/C servo outputs, two analogue inputs, four digital inputs and three digital outputs, which allow you to control a wide range of external devices in your system. The servos can be controlled by mouse and/or joystick. The controller is fully addressable, therefore up to four controllers can be controlled from one serial port
OUR PRICE: £ 84.99
NO LONGER AVAILABLE
 
Robotica Relay Board
The Robotica Relay Board is designed for easy control of AC/DC loads, motors, solenoids, lights etc. It can be controlled both digitally and stand-alone.

Robotica Relay Board operates with 5-8 V DC at 150mA (8-15V Relay version is also available) and it is capable of handling loads up to 8A at 0-250V.

Relay Board is fully compatible with the R/C Servo Controller II and Expander.
OUR PRICE : £ 12.99

NO LONGER AVAILABLE
 
Robotica Expander
Pulse-to-Digital Output Converter
The Robotica Expander converts the pulse output of your R/C Servo Controller into two digital outputs, allowing you to control AC/DC motors, relays, solenoids and other devices from R/C servo outputs.

When the pulse width at the input is above 1.7 ms, the Expander sets its Output 1 high and Output 2 low, and when it is below 1.3 ms then it sets Output 1 low and Output 2 high.

Both outputs will be low when the input pulse width is between 1.3 ms and 1.7 ms, as the Expander does not respond to a signal with a pulse width at these values.

Expander is fully compatible with the R/C Servo Controller II and Relay Board.

Expander operates with 8-24V unregulated DC voltage.
Pulse Input (fed by R/C Servo Output) <1.3ms 1.3ms - 1.7ms >1.7ms
Digital Output 1 OFF OFF ON
Digital Output 2 ON OFF OFF

OUR PRICE : £ 15.99 NO LONGER AVAILABLE
 
 
To pages - 0 -

HOME

© 2002 RobotstoreUK all rights reserved

 

 

Relevent Book



Programming Robot Controllers